Features
- Tunable across 3 frequency blocks
- Digital Hybrid Wireless® audio for compandor-free digital quality
- Selectable 25 or 50 mW RF power
- Compatibility modes for use with analog receivers
- 25 or 100 kHz tuning steps
- Wide range input gain control in 1 dB steps
- Quick change Lithium-ion rechargeable battery
- Audio coupled remote control
The SSM is ideal in theatrical or any other production where concealment in costuming is required. In spite of its tiny size, the transmitter offers an extensive feature set and performance on par with all of the Digital Hybrid Wireless® models.
Frequencies are selectable in 100 kHz or 25 kHz steps across a maximum tuning range of 76.7 MHz. This yields a total of 3072 available frequencies across three standard frequency blocks. The tuning range varies in other blocks to meet applicable frequency allocations.
The servo bias input accepts mic or line level signals with a wide range of gain adjustment in 1 dB steps. Accurate LED indications on the keypad allow precise gain adjustments to be made for the maximum signal to noise ratio and minimum distortion. The limiter in the preamp can cleanly handle signal peaks over 30 dB above full modulation, allowing the input gain to be set high enough to achieve the maximum signal to noise ratio, yet provide protection against input overload.
Along with providing peerless audio quality with wide frequency response and dynamic range in Nu Hybrid mode, the technology used in the SSM includes compatibility modes for Lectrosonics Mode 3 and IFB receivers.
Included Accessories
- 1 - 26995 Belt Clip
- 1 - 27079 ANTENNA UP BELT CLIP
- 1 - 35939 Pouch
- 1 - 40106-1 Lithium Batteries
- 1 - 40102 Battery Charger
- 3 - P1311 USB Port Plug
Specifications
Operating Frequencies: SSM: Band A1: 470.100 - 537.575 Band B1: 537.600 - 607.950
Frequency Selection Steps: Selectable; 100 kHz or 25 kHz
RF Power output: SSM/E01/E01-B2/X: Selectable; 25 or 50 mW SSM/E02: 10 mW SSM/E06: 50 or 100 mW EIRP
Compatibility Modes: US: Nu Hybrid, Mode 3, IFB E01: Digital Hybrid, Mode 3, IFB E01-B2: Digital Hybrid, Mode 3, IFB E02: Digital Hybrid, Mode 3, IFB E06: 100 Series, 200 Series, Mode 3, Digital Hybrid, IFB, Mode 6, Mode 7 SSM/X: 100 Series, 200 Series, Mode 3, Digital Hybrid, IFB, Mode 6, Mode 7 Pilot tone: 25 to 32 kHz; 3.5 kHz deviation (Nu Hybrid mode); ± 50 kHz max. (Digital Hybrid mode)
Frequency Stability: ± 0.002%
Operating temp. range: Celsius: -20° - 40° Farenheit: -5° - 104°
Spurious radiation: SSM: Compliant with ETSI EN 300 422-1 v1.4.2 SSM-941/E01/E02/E06/X: 60 dB below carrier
Equivalent input noise: –120 dBV (A-weighted)
Input level: Nominal 2 mV to 300 mV, before limiting. Greater than 1V maximum, with limiting.
Input impedance: • Mic: 300 or 4.5 k ohm; selectable • Line: greater than 100 k ohm Input limiter: DSP controlled, dual envelope “soft” limiter with greater than 30 dB range
Gain control range: 44 dB; digital control
Modulation indicators: Dual bicolor LEDs indicate modulation of -20, -10, 0 and +10 dB referenced to full modulation
Audio Performance (Digital Hybrid and Nu Hybrid)
Frequency Response: 70 Hz to 20 kHz (+/-1dB)
Low frequency roll-off: –12 dB/octave; 70 Hz THD: 0.2% (typical)
Controls: Side panel membrane switches with LCD interface for power on/off and all setup and configuration controls
Audio Input Jack: LEMO 00 Series 3-pin
Antenna: Galvanized steel, flexible wire
Battery: Lithium-ion 3.6 V 1000 mAH LB50 battery pack
Battery Life: 6 hours per charge
Weight: 2.3 ounces (65.2 grams) including lithium battery pack
Dimensions (housing): 2.3 x 1.5 x .56 in. (58.4 x 38 x 14.2 mm)
Emission Designator: SSM: 110KF3E
SSM/E01/E01-B2/E02/E06/X: 180KF3E
Specifications | |
Capacity | Specifications Operating Frequencies: SSM: Band A1: 470.100 - 537.575 Band B1: 537.600 - 607.950 Frequency Selection Steps: Selectable; 100 kHz or 25 kHz RF Power output: SSM/E01/E01-B2/X: Selectable; 25 or 50 mW SSM/E02: 10 mW SSM/E06: 50 or 100 mW EIRP Compatibility Modes: US: Nu Hybrid, Mode 3, IFB E01: Digital Hybrid, Mode 3, IFB E01-B2: Digital Hybrid, Mode 3, IFB E02: Digital Hybrid, Mode 3, IFB E06: 100 Series, 200 Series, Mode 3, Digital Hybrid, IFB, Mode 6, Mode 7 SSM/X: 100 Series, 200 Series, Mode 3, Digital Hybrid, IFB, Mode 6, Mode 7 Pilot tone: 25 to 32 kHz; 3.5 kHz deviation (Nu Hybrid mode); ± 50 kHz max. (Digital Hybrid mode) Frequency Stability: ± 0.002% Operating temp. range: Celsius: -20° - 40° Farenheit: -5° - 104° Spurious radiation: SSM: Compliant with ETSI EN 300 422-1 v1.4.2 SSM-941/E01/E02/E06/X: 60 dB below carrier Equivalent input noise: –120 dBV (A-weighted) Input level: Nominal 2 mV to 300 mV, before limiting. Greater than 1V maximum, with limiting. Input impedance: • Mic: 300 or 4.5 k ohm; selectable • Line: greater than 100 k ohm Input limiter: DSP controlled, dual envelope “soft” limiter with greater than 30 dB range Gain control range: 44 dB; digital control Modulation indicators: Dual bicolor LEDs indicate modulation of -20, -10, 0 and +10 dB referenced to full modulation Audio Performance (Digital Hybrid and Nu Hybrid) Frequency Response: 70 Hz to 20 kHz (+/-1dB) Low frequency roll-off: –12 dB/octave; 70 Hz THD: 0.2% (typical) Controls: Side panel membrane switches with LCD interface for power on/off and all setup and configuration controls Audio Input Jack: LEMO 00 Series 3-pin Antenna: Galvanized steel, flexible wire Battery: Lithium-ion 3.6 V 1000 mAH LB50 battery pack Battery Life: 6 hours per charge Weight: 2.3 ounces (65.2 grams) including lithium battery pack Dimensions (housing): 2.3 x 1.5 x .56 in. (58.4 x 38 x 14.2 mm) Emission Designator: SSM: 110KF3E SSM/E01/E01-B2/E02/E06/X: 180KF3E |
Lectrosonics - SSM Digital Hybrid Wireless® Micro Transmitter
- Brand: Lectrosonics
- Product Code: SSM
-
$2,412.00