Features

Covers two frequency blocks in the US; three in Europe
Digital Hybrid Wireless® for compandor-free audio
Selectable 50 or 100mW output power
Compatibility modes for use with analog receivers
25 or 100 kHz tuning steps for up to 3072 selectable frequencies
Integrated multi-function switch for mute or talkback modes
Wide range input gain control in 1 dB steps
IR port for setup with IR enabled receivers
USB port for firmware updates
Menu selectable mic or instrument input
Optional battery eliminator
Detachable antenna

The LT transmitter offers a full set of professional features in a compact, rugged package. The unit is compatible with all Digital Hybrid Wireless® receivers and even some from other manufacturers, making it comfortable in a wide variety of applications from video production to theater, stage and house of worship.

The LT can be configured to operate as a "one touch" device with a single power on/off switch on the top panel, or with full access to all operational parameters using the side panel membrane switches and LCD interface. The top panel switch can also be configured to provide a mute or talkback function.

Included Accessories

2 - AA Batteries
1 - AMMXX (Specify Block)
1 - 26895 Wire Belt Clip (Installed on Transmitter)

Specifications
Capacity	Specifications Operating Frequencies: US: Band A1: 470.100 - 537.575 Band B1: 537.600 - 607.950 Frequency Selection Steps: US: Selectable; 100 kHz or 25 kHz E01: Selectable; 100 kHz or 25 kHz E06: Selectable; 100 kHz or 25 kHz X: Selectable; 100 kHz or 25 kHz RF Power output: US: Selectable: 50 or 100mW E01: 50mW E06: < 100 mW EIRP X: 50 or 100 mW Compatibility Modes: US: Nu Hybrid, IFB, Mode 3 E01: Hybrid, IFB E06: Hybrid, IFB X: Hybrid, IFB Pilot tone: 25 to 32 kHz; 3 kHz deviation (Digital Hybrid) 25 to 32 kHz; 3.5 kHz deviation (Nu Hybrid) Frequency Stability: ± 0.002% Spurious radiation: US: Compliant with ETSI EN 300 422-1 v1.4.2 E01/E06/X: 60 dB below carrier Equivalent input noise: –120 dBV (A-weighted) Input level: Mic: • Nominal 2 mV to 300 mV, before limiting Greater than 1V maximum, with limiting Instrument: • 1M Ohm high level Input impedance: Line: 2k Ohm; Mic: 300 Ohm Input limiter: DSP controlled, dual envelope “soft” limiter with greater than 30 dB range Gain control range: 44 dB; digital control Modulation indicators: • Dual bicolor LEDs indicate modulation of -20, -10, 0 and +10 dB referenced to full modulation • LCD bar graph Controls: • Top panel slide switch; programmable as power, mute, talkback or no (off) function • Side panel membrane switches with LCD interface for power on/off and all setup and configuration controls Audio Input Jack: Switchcraft 5-pin locking (TA5F) Antenna: Galvanized steel, flexible wire Battery: Two AA; alkaline, lithium, NiMH rechargeable Battery Life: • Duracell Quantum: 4.75 hours • Eneloop 2400 mAH NiMH: 5.5 hours Weight: 5.9 ounces (169 grams), with lithium AA batteries Dimensions: 2.85 x 2.45 x .75 in. (72 x 62 x 19 mm) Emission Designator: 110KF3E (LT) 180KF3E (E01/E06/X) Frequency Response: Line/Instrument: 35 Hz to 20 kHz (+/-1dB) Mic input: 35 Hz to 20 kHz (+/-1dB) Mic input LF roll-off: Selectable knee at 35, 50, 70, 100, 120, 150 Hz THD: 0.2% (typical)

Specifications

Capacity

Specifications

Operating Frequencies: US: Band A1: 470.100 - 537.575 Band B1: 537.600 - 607.950

Frequency Selection Steps: US: Selectable; 100 kHz or 25 kHz E01: Selectable; 100 kHz or 25 kHz E06: Selectable; 100 kHz or 25 kHz X: Selectable; 100 kHz or 25 kHz RF Power output: US: Selectable: 50 or 100mW E01: 50mW E06: < 100 mW EIRP X: 50 or 100 mW

Compatibility Modes: US: Nu Hybrid, IFB, Mode 3 E01: Hybrid, IFB E06: Hybrid, IFB X: Hybrid, IFB Pilot tone: 25 to 32 kHz; 3 kHz deviation (Digital Hybrid) 25 to 32 kHz; 3.5 kHz deviation (Nu Hybrid)

Frequency Stability: ± 0.002%

Spurious radiation: US: Compliant with ETSI EN 300 422-1 v1.4.2 E01/E06/X: 60 dB below carrier

Equivalent input noise: –120 dBV (A-weighted)

Input level: Mic: • Nominal 2 mV to 300 mV, before limiting Greater than 1V maximum, with limiting Instrument: • 1M Ohm high level Input impedance: Line: 2k Ohm; Mic: 300 Ohm Input limiter: DSP controlled, dual envelope “soft” limiter with greater than 30 dB range

Gain control range: 44 dB; digital control

Modulation indicators: • Dual bicolor LEDs indicate modulation of -20, -10, 0 and +10 dB referenced to full modulation • LCD bar graph Controls: • Top panel slide switch; programmable as power, mute, talkback or no (off) function • Side panel membrane switches with LCD interface for power on/off and all setup and configuration controls

Audio Input Jack: Switchcraft 5-pin locking (TA5F)

Antenna: Galvanized steel, flexible wire

Battery: Two AA; alkaline, lithium, NiMH rechargeable Battery Life: • Duracell Quantum: 4.75 hours • Eneloop 2400 mAH NiMH: 5.5 hours

Weight: 5.9 ounces (169 grams), with lithium AA batteries

Dimensions: 2.85 x 2.45 x .75 in. (72 x 62 x 19 mm)

Emission Designator: 110KF3E (LT) 180KF3E (E01/E06/X)

Frequency Response: Line/Instrument: 35 Hz to 20 kHz (+/-1dB) Mic input: 35 Hz to 20 kHz (+/-1dB) Mic input LF roll-off: Selectable knee at 35, 50, 70, 100, 120, 150 Hz THD: 0.2% (typical)