Features
- Continuously tunable tracking filters covering 470.100 - 614.375 MHz
- Compatible with D2, Duet and Digital Hybrid Wireless® transmitters
- Vector Diversity with two receivers per channel for superior digital signal recovery
- High IP3 and high-current front ends for robust performance even in severe RF environments
- IR bi-directional port for transmitter setup
- Analog and Digital audio outputs with TalkBack (in applicable RX modes)
- USB interface
- Up to 4 channel recording on microSD card (depending on RX modes)
- AA Battery or external powering
- Same cross-section as the UCR411a for mounting using existing hardware
- Bright, high-density OLED display for clear viewing in any lighting conditions
- AES 256-bit, CTR mode encryption, with 4 different key policies available
The DCR822 compact 2-channel digital receiver with analog and digital audio outputs utilizes the Lectrosonics signature digital architecture with remarkable audio quality and ultra-low latency. The receiver includes an extended operating range rivaling the best analog and Digital Hybrid Wireless® systems with continuously tunable tracking filters covering the entire frequency band of the unit. The innovative Vector Diversity technology raises the bar for digital transmission integrity with two RF front ends per channel, and a unique phase-matching system. The extremely robust RF front ends of the receiver will hold up in severe RF environments and close carrier spacing, whether analog or digital. The DCR822 has a flexible output routing scheme, allowing a variety of applications including Talkback. And, a digital recorder at 24 bits, 48 kHz is included – and records up to 4 audio tracks on a front-mounted microSD card.
The 822 receiver is compatible with pure digital transmitters from the D Squared line including the DBSM, DBSMD, DBu, DHu, DPR and DPR-A. The 822 is also compatible with stereo digital transmitters including the DCHT and M2T. Finally, the receiver is also backward compatible with any Digital Hybrid Wireless transmitter made in the last 20 years.
Included Accessories
- 4x AA Batteries
- MicroSD card (part# 55010)
- A1B1 version: 2x AMJ-19 and 2x AMJ-22 antennas
- B1C1 version: 2x AMJ-22 and 2x AMJ-25 antennas
- 941 version: 2x AMJ-944 antennas
- CCMINI zippered pouch
Specifications | |
Capacity | Specifications Operating Frequencies (MHz): Model A1/B1: 470.100 - 614.375 Model B1/C1: 537.600 - 691.175 Model 941: 941.525 - 951.975 952.875 - 956.225 956.475 - 959.825 Frequency Selection Steps: 25 kHz Frequency Response: 25 Hz to 20 kHz (+0/-3 dB) Frequency Stability: ±0.001% Front end bandwidth: ±5.5 MHz, @ -3 dB Sensitivity: 20 dB Sinad: 0.9 uV(-108 dBm), A weighted 60 dB Quieting: 1.12 uV (-105 dBm), A weighted AM rejection: >60 dB, 2 uV to 1 Volt Modulation acceptance: 85 kHz Spurious rejection: 85 dB Third order intercept: +15 dBm Audio Performance (overall system): THD: 0.2% (typical) SNR at receiver output (dB): SmartNR No Limiting w/Limiting OFF 103.5 108.0 NORMAL 107.0 111.5 FULL 108.5 113.0 Note: The dual envelope “soft” limiter provides exceptionally good handling of transients using variable attack and release time constants. Once activated, the limiter compresses 30+ dB of transmitter input range into 4.5 dB of receiver output range, thus reducing the measured figure for SNR without limiting by 4.5 dB Diversity method: Vector Diversity Antenna inputs: Dual SMA female jacks; 50 Ohm impedance Audio output: Rear panel 2 TA3M connectors; can drive 600 Ohm, adjustable from -50 to +5 dBu in 1 dB steps (into nominal 10 k bal. load) Input Dynamic Range: 125 dB (with full Tx limiting) Overall Latency (time delay): 1.4 ms with digital source, <2.9 ms with Hybrid TX Audio Test Tone: 1 KHz, -50 to +5 dBu, <1%THD Controls: Front Panel: • LCD display • Menu/Sel, Pwr/Back, Up/Down Arrow Buttons • SD Card Reader • IR Port Rear Panel: • Analog/AES audio output jack (2) • External DC input • Battery compartment • USB port External Power: Minimum 9 Volts to maximum 17 VDC 2.5 W; 170 mA at 12 VDC Battery Life: 6 hrs. continuous, w/ 4 disposable, 1.5VDC AA Lithium batteries (recommended) Weight: 408 grams with batteries (14.4 oz.) Dimensions: 3.23” wide x 1.23” high x 4.75” deep 82.042 wide x 31.242 high x 120.650 deep m |
Lectrosonics - DCR822-A1B1 Digital Compact Dual Receiver
- Brand: Lectrosonics
- Product Code: DCR822
-
$3,862.00
Related Products
Lectrosonics - DBSM-A1B1 Digital Wireless Transmitter
FeaturesRF Power selections at 10, 25 and 50 mWUltra-lightweight, corrosion resistant housingOLED in..
$1,853.00
Lectrosonics - DSQD Digital 4 Channel Receiver
FeaturesFour-channel, half-rack designContinuously tunable tracking filters covering 470.100 - 614...
$5,675.00
Lectrosonics - DPR/DPR-A Plug-On Digital Transmitter
FeaturesWideband UHF tuning range – 470-608 MHz (470-614 MHz for E01 version)Accepts microphone or l..
$1,771.00
Lectrosonics - DBSMD-A1B1 Digital Wideband Wireless Transmitter
FeaturesRF Power selections at 10, 25 and 50 mWUltra-lightweight, corrosion resistant housingOLED in..
$1,920.00
Lectrosonics - DHu-A1B1 Digital Wideband Handheld Transmitter
Features4th generation digital design256-bit encryption - AES 256-CTRInterchangeable thread-on capsu..
$1,823.00
Lectrosonics - DSR4-A1B1 Four Channel Digital Slot Receiver
FeaturesTwo diversity options for maximum flexibility24 bit/48 kHz digital for flawless audioAES 256..
$4,449.00
Lectrosonics - DSR 2-Channel Digital Slot Receiver
FEATURESTwo independent channels, compact designVector diversity for superior performanceLatest gene..
$2,989.00